JLG 460SJ Service Manual - Manual (Page 68)

SECTION 3 - CHASSIS & TURNTABLE
3-16 – JLG Lift – 3120895
3. Place internal gear (2) into hub (1G) so that its inter-
nal splines mesh with the external splines of spindle
(1A). Oil internal gear (2).
4. Place thrust washer (11) around spindle (1A) so it
rests on the bottom of the internal gear (2).
5. Stand input shaft (7A) on its splined end. Place one
spacer (7D) onto the smooth end of input shaft (7A).
6. Place one spring (7C) onto the smooth end of input
shaft (7A).
7. Place other spacer (7D) onto the smooth end of
input shaft (7A).
WEAR SAFETY GLASSES DURING THIS STEP, AND BE AWARE THAT
SPRING AND SPACERS, COMPRESSED BY RETAINING RING, MAY
POP SUDDENLY OFF SHAFT IF THE RING IS RELEASED BEFORE IT
IS PROPERLY IN PLACE.
8. Using retaining ring pliers, insert retaining ring (7B)
into the groove on input shaft (7A) by compressing
the spring and spacers together.