ElmoMC Gold Line Digital Servo Drives-Gold Solo Trombone - Manual (Page 13)

Gold Solo Trombone Installation Guide Product Description
MAN-G-SOLTROIG (Ver. 1.3)
www.elmomc.com
13
2.2. Product Features
Note: The features described in this chapter relate to the range of Gold Solo Trombone
models. Depending on the model you have purchased, not all features are available.
To see the features for your model, look at the product label on the Gold Solo Trombone and
use the product catalog number schematic that appears at the beginning of this manual and on
page 23 to determine which specific features are available to you.
2.2.1. Servo Control
• Advanced and extremely fast vector control algorithm (current loop bandwidth: 4 kHz)
• Current/Torque sampling rate: up to 20 kHz (50 μs)
• Velocity sampling rate: up to 10 kHz (100 μs)
• Position sampling rate: up to 10 kHz (100 μs)
• Electrical commutation frequency: up to 4 kHz
• Current closed loop bandwidth exceeds 4 kHz
• Position/Velocity/Acceleration command range – full 32 bit
• Position over velocity, with full dual loop support
• Current gain scheduling to compensate for the motor’s non-linear characteristics
• Advanced filtering: Low pass, Notch, General Biquad
• Current loop gain scheduling to compensate for bus voltage variations
• Velocity gain scheduling for ultimate velocity loop performance
• Gains and filter scheduling vs. position for mechanical coupling optimization, speed and
position tracking errors
• High order filters gain scheduling vs. speed and position
• S-curve Profile Smoothing
• Cogging, BEMF and ωxL compensation
• Dual Loop Operation supported by Auto Tuning
• Fast, easy and efficient advanced Auto Tuning
• Incremental encoder frequency of up to 75 Megacounts/sec
• Motion profiler numeric range:
 Position up to ±2 x 10 9 counts
 Velocity up to 2 x 10 9 counts/sec
 Acceleration up to 2 x 10 9 counts/sec 2