Resolver, Port c – emulated encoder output, N 4.9.3 – ElmoMC Gold Line Digital Servo Drives-Gold Solo Trombone User Manual
Page 65
Gold Solo Trombone Installation Guide
Installation
MAN-G-SOLTROIG (Ver. 1.3)
65
4.9.2.3.
Resolver
Figure 24: Port B – Resolver Connection Diagram
4.9.3.
Port C – Emulated Encoder Output
Port C provides emulated encoder output derived from port A or port B feedback inputs, or
from internal variables. The output options are:
• Port A/B daisy chain (1:1) for incremental encoder
• Encoder emulation: Emulate any input sensor, digital or analog, or use to emulate an
internal variable such as virtual profiler.
• PWM output: Any pair of outputs that is used as an encoder channel (e.g. channel A+ and
channel A-) can be configured by software to become PWM output.
• Pulse & Direction output: The output pins that are assigned as channel A and channel B
when used as encoder out, can be configured by software to become pulse and direction
outputs respectively.
This port is used when:
• The Gold Solo Trombone is used as a current amplifier to provide position data to the
position controller.
• The Gold Solo Trombone is used in velocity mode, to provide position data to the position
controller.