Warnings, Cautions, Warnings 1.2. cautions – ElmoMC Gold Line Digital Servo Drives-Gold Solo Trombone User Manual

Page 9

Advertising
background image

Gold Solo Trombone Installation Guide

Safety Information

MAN-G-SOLTROIG (Ver. 1.3)

www.elmomc.com

9

1.1. Warnings

Cleaning after soldering. To avoid damage to the product’s acrylic coating, the Gold Solo
Trombone must not be cleaned after soldering with soluble solvents or water-based
cleaners. For further details, see

www.elmomc.com/applications/article/Soldering-and-

Cleaning_Application-Note.pdf

.

• Power cables can carry a high voltage, even when the motor is not in motion. Disconnect

the Gold Solo Trombone from all voltage sources before it is opened for servicing.

• The Gold Solo Trombone servo drive contains grounding conduits for electric current

protection. Any disruption to these conduits may cause the instrument to become hot (live)
and dangerous.

• After shutting off the power and removing the power source from your equipment, wait at

least 1 minute before touching or disconnecting parts of the equipment that are normally
loaded with electrical charges (such as capacitors or contacts). Measuring the electrical
contact points with a meter, before touching the equipment, is recommended.

1.2. Cautions

• The Gold Solo Trombone servo drive contains hot surfaces and electrically-charged

components during operation.

• The maximum DC power supply connected to the instrument must comply with the

parameters outlined in this guide.

• When connecting the Gold Solo Trombone to an approved isolated auxiliary power supply,

connect it through a line that is separated from hazardous live voltages using reinforced or
double insulation in accordance with approved safety standards.

• Before switching on the Gold Solo Trombone, verify that all safety precautions have been

observed and that the installation procedures in this manual have been followed.

Advertising