Rockwell Automation 1492-PRINT110_PRINT220 ClearTools User Manual - Manual (Page 151)

User Manual Print

145
7 Single Pages
Selection of specific pages of different marker types to be printed.
8 Selected markers
Select whether the project markers are also printed or whether the markers remain
at their position or are combined.
9 Offset
The Print dialog shows an "Offset" box, provided only one marker type has been
selected for printing.
The offset shifts the start position for the printout from the first marker to a different
one.
For example, if you set the offset to 8, the first seven markers remain blank and
the printing starts at the eighth marker. The default setting is 1.
10 Type
All printable marker types in the current project.
11 Marker type title/variant name
The marker type title. One click on the column heading switches the view to the
variant name (see chapter "Renaming a product").
12 Pages
Number of printable pages of the marker type
13 Number
How often shall the marker type in the list be printed?
Click into the field and enter the number of copies.
Note that the number is multiplied by the number of copies.
14 Printer
The printer mapped to the marker type. To change the mapping, see chapter
"Mapping the printer and marker type".
15 Heating level
The required heating level for the marker type (depends on the selected printer).
16 Show marker type change
If there are several marker types in the print process, a dialog is shown before a
change to another marker type is made, so that e.g. the printer magazine/the
plotter fixture can be changed.
Mapping the printer and marker type
As a default, no marker type is mapped to a printer.
If no printer has been mapped to any or all of the marker types to be printed, confirming the
message shown sends the data to the default printer.

Open the print dialog using the menu items File > Print…

In the lower field select the marker type that you want to map to a printer.

Then select a printer from the "Printer" field and click the Map button..

In the selection dialog that follows, select whether the selected printer is a printer or a plotter.
The selected printer and marker type are automatically mapped whenever printing takes place.
To map the marker type to a different printer, select the required printer from the
installed printers or activate the mapping dialog (see "Options dialog").