Rockwell Automation 1492-PRINT110_PRINT220 ClearTools User Manual - Manual (Page 169)

User Manual Activating the plotter

163
Adjusting the pen test position
The default pen test position of the plotter is set to two blocks adjacent to the pen holder, which,
not surprisingly, very quickly become dirty.
To adjust the pen test position, select Tools > Options... > Plotter
The pen test position of the plotter can be set on the "Pen Priming" page.
The adjusted pen test position is only valid for Marker Cards. The default plotter position is still
used for labels.
The adjusted pen test position takes into account the Offset X and Offset Y parameters of the
Marker Cards correction.

Please note that an incorrectly selected pen test position may result in damage
to the pen. Always test your settings without a pen first!