Rockwell Automation 1492-PRINT110_PRINT220 ClearTools User Manual - Manual (Page 31)

User Manual General Operation

25
The dialog contains the following buttons:
Click on the OK button to confirm your input.
Click on the Cancel button to cancel the process.
Click on the Help button to load the Help.
Click on the Last sequence button to load the last sequence
you used.
Click on the Reset to default button to restore the
predefined default values.
In the "System" group, select the notation you want to use for numbering.
Decimal
This uses the decimal system, i.e. the ten digits from 0 to 9, then 10, 11, 12, etc.
PLC / Octal
Choose this option to select a PLC-specific labeling format. The PLC labeling format usually
includes two counters, separated by a full stop (e.g. 4.0).
Counter Y uses the octal system from 0 to 7, and block counter X starts from the start value in
the Block field and counts at the increment specified in the Block Step field. The Prefix field
usually contains a letter (e.g. I for Input), and a Suffix can also be defined (see example 2).
Hexadecimal
This notation is based on the hexadecimal system, which uses the characters 0 to 9, A, B, C, D,
E, F.
Example: 0, 1, ….9, A, B, C, D, E, F, 10, 11, …,18, 19, 1A, 1B, 1C, 1D, 1E, 1F, 20, … 29, 2A, …
2F, 30, … etc.
Alphanumeric
Three numbering sequences are possible with this option: a to z or A to Z or 0 to 9.
Example: b to m (only one character is allowed, not AA to ZZ for example).
Character string
The same word is written to all the text fields, e.g. "ISB". Character strings: 1234 or ABCD or
1a2Bd3.