Terminal wiring, Module removal procedure -7, Terminal wiring -7 – Rockwell Automation 1746-NT4 Series B,D17466.6.1 SLC 500 4-Channel Thermocouple/mV Input Module User Manual User Manual
Page 35: Module removal procedure
Publication 1746-UM007C-EN-P - July 2004
Installation and Wiring 3-7
3. Cover all unused slots with the Card Slot Filler, Catalog Number
1746-N2.
Module Removal Procedure
1. Press the releases at the top and bottom of the module and slide
the module out of the chassis slot.
2. Cover all unused slots with the Card Slot Filler, Catalog Number
1746-N2.
Terminal Wiring
The thermocouple module contains a green, 18-position, removable
terminal block. The terminal pin-out is shown on page 3-8.
Card Guide
Top and Bottom
Module Release(s)
ATTENTION
Disconnect Power to the SLC before attempting to
install, remove, or wire the removable terminal
wiring block.
To avoid cracking the removable terminal block,
alternate the removal of the slotted terminal block
release screws.