Rockwell Automation 1746-HSCE,D17466.5 High-Speed Counter Module - Manual (Page 3)

Publication 1746-UM006B-EN-P - August 2005
Summary of Changes
The information below summarizes the changes to this manual since
the last printing.
To help you find new and updated information in this release of the
manual, we have included change bars as shown to the right of this
paragraph.
New Information The table below lists sections that document new features and
additional information about existing features, and shows where to
find this new information.
Obsolete Information Procedures for configuring your High-Speed Counter module using
APS and HHT software were removed from Chapter 4.
G-File and Interrupt Operation information were removed from
Appendix B.
Special Considerations When Using APS Versions 2.01 and 3.01
(Appendix D) was removed from the manual.
For information on See
Application errors Module Count will not
Reset on page 5-6
Updated binary and decimal Configuration Data Tables for
the Range Mode drilling example Configuration Data Tables
on page 6-16
Updated binary and decimal Configuration Data Tables for
the Rate Mode log ripper example Configuration Data Tables
on page 6-25
Updated binary and decimal Configuration Data Tables for
the Sequencer Mode cut-to-length example Configuration Data Tables
on page 6-36