Removing the terminal block, Removing the terminal block -9 – Rockwell Automation 1746-HSCE,D17466.5 High-Speed Counter Module User Manual
Page 53
Advertising
Publication 1746-UM006B-EN-P - August 2005
Installation and Wiring 3-9
Removing the Terminal
Block
The removable terminal wiring block eliminates the need to rewire a
module if it is removed from the rack. Each terminal will accept two
#14 AWG wires.
Remove the terminal block by turning the slotted terminal block
release screws counterclockwise. The screws are attached to the
terminal block, so it will follow as the screws are turned out.
ATTENTION
Disconnect power before attempting to install,
remove, or wire the removable terminal wiring
block.
To avoid cracking the removable terminal block,
alternate the removal of the slotted terminal block
release screws.
Terminal Block
Release Screws
OUTPUT
HSCE
FAULT
1
2
3
4
5
6
7
0
A
B
Z
LS
INPUT
Advertising