Install the armorpoint i/o adapter module, Wire the point i/o adapter – Rockwell Automation 1738-AENTR, Series A 1734 POINT I/O and 1738 ArmorPOINT I/O 2 Port Ethernet/IP Adapter User Manual User Manual
Page 22
14
Rockwell Automation Publication 1734-UM014B-EN-P - June 2013
Chapter 2 Install Your Adapter
Install the ArmorPOINT I/O
Adapter Module
To install the ArmorPOINT I/O adapter module:
1. Using a bladed screwdriver, rotate the keyswitch on the mounting base
clockwise until the appropriate number for the I/O module you are
installing aligns with the notch in the base.
Refer to the installation instructions for each module to determine what
this number must be. See
for a list of
these installation instructions.
2. Position the module vertically above the mounting base.
The module bridges two bases.
3. Push the module down until it engages the latching mechanism.
You hear a clicking sound when the module is properly engaged. The
locking mechanism locks the module to the base.
Wire the POINT I/O Adapter
Refer to the following illustration to wire the adapter.
ATTENTION: Do not connect 120/240V AC power to the V DC supply.
ATTENTION: Do not wire more than two conductors on any single
terminal.
ATTENTION: Make sure all connectors and caps are securely tightened
to properly seal the connections against leaks and maintain IP67
requirements.
NC
C
V
NC
Chas
Gnd
C
V
NC = No Connection
Chas Gnd = Chassis Ground
C = Common
V = Supply
0
4
2
6
Chas
Gnd
12/24V DC
This DC supply connects
to the internal power bus.
1
5
3
7
V DC