Add the i/o adapter to the i/o configuration – Rockwell Automation 1738-AENTR, Series A 1734 POINT I/O and 1738 ArmorPOINT I/O 2 Port Ethernet/IP Adapter User Manual User Manual
Page 60
Advertising
52
Rockwell Automation Publication 1734-UM014B-EN-P - June 2013
Chapter 5 Configure the Adapter for Direct Connection and Rack Optimization in RSLogix 5000 Software
7. Click OK to accept the configuration.
Add the I/O Adapter to the I/O Configuration
Next, you must add the I/O adapter as a child of the local 1756-ENBT module.
1. In the Project dialog, right-click the local 1756-ENBT module under the
I/O Configuration folder, and select New Module
from the dialog.
The Select Module dialog opens.
Advertising
This manual is related to the following products: