Rockwell Automation 1738-AENTR, Series A 1734 POINT I/O and 1738 ArmorPOINT I/O 2 Port Ethernet/IP Adapter User Manual User Manual
Page 66
Advertising
58
Rockwell Automation Publication 1734-UM014B-EN-P - June 2013
Chapter 5 Configure the Adapter for Direct Connection and Rack Optimization in RSLogix 5000 Software
Add the POINT I/O Module and Configure For Direct Connection
1. Right-click the POINT I/O Chassis in the I/O Configuration folder, and
select New Module
.
The Select Module dialog opens.
2. Expand the Digital tree.
IMPORTANT
If you exceed the adapter chassis size trying to add more modules
than you configured, the New Module selection appears dim and is
disabled. Increase the adapter chassis size to add more I/O modules.
Advertising
This manual is related to the following products: