Overview, Configure the adapter for your ethernet/ip network, Chapter – Rockwell Automation 1738-AENTR, Series A 1734 POINT I/O and 1738 ArmorPOINT I/O 2 Port Ethernet/IP Adapter User Manual User Manual
Page 25
Rockwell Automation Publication 1734-UM014B-EN-P - June 2013
17
Chapter
3
Configure the Adapter for Your EtherNet/
IP Network
Overview
Before using your adapter in an EtherNet/IP network, you need to configure it
with an IP address, subnet mask, and optional Gateway address. This chapter
describes these configuration requirements and the procedures for providing
them. Here are ways you can do this:
•
Use the Rockwell BootP/DHCP utility, version 2.3 or later, that ships
with RSLogix 5000 or RSLinx software.
–
You can also use this utility to reconfigure a device with an IP address
you must change.
•
Use a
third party DHCP server.
•
Use the Network Address thumbwheel switches.
•
Have your network administrator configure the adapter via the network
DHCP server.
See the table for a list of where to find information in this chapter.
Topic
Page
Set the Network Address for POINT I/O Adapter
Set the Network Address for ArmorPOINT I/O Adapter
Use the Rockwell BootP/DHCP Utility