Use the identity page – Rockwell Automation 1738-AENTR, Series A 1734 POINT I/O and 1738 ArmorPOINT I/O 2 Port Ethernet/IP Adapter User Manual User Manual
Page 94
86
Rockwell Automation Publication 1734-UM014B-EN-P - June 2013
Chapter B Adapter Web Dialogs
1. From the Home page, click Configuration or Expand to see the
Configuration options, if needed.
2. From the Configuration page, click one of the following:
•
Identity
•
Network
•
Services
A login dialog opens as shown. The dialog may vary in appearance
depending on your operating system and browser.
3. From the user name and password dialog, enter values, noting the
following:
•
The values for user name and password are case sensitive.
•
The default user name is admin.
•
The default password is "password".
4. Click OK to log in. After you log in, you can go to any of the
Configuration pages without having to log in again.
5. Refer to the section of this manual that corresponds to the section you
clicked:
•
Identity
•
Network Configuration
•
Services
Use the Identity Page
To use the Identity page to make entries for the host name, module description,
module location, and chassis size, use this procedure.
1. Click Identity from the tab at the top of the page or panel on the left.