Configure the i/o modules – Rockwell Automation 1738-AENTR, Series A 1734 POINT I/O and 1738 ArmorPOINT I/O 2 Port Ethernet/IP Adapter User Manual User Manual
Page 58
50
Rockwell Automation Publication 1734-UM014B-EN-P - June 2013
Chapter 5 Configure the Adapter for Direct Connection and Rack Optimization in RSLogix 5000 Software
Configure the I/O Modules
You now add the I/O modules to the controller I/O configuration. To do this,
first add the local 1756-ENBT module to the I/O configuration. Next, add the I/
O adapter as a child of the 1756-ENBT module, and then add the I/O modules
as children of the adapter.
Add the Local EtherNet/IP Bridge to the I/O Configuration
1. Right-click the I/O Configuration folder in the project dialog and select
New Module...
2. The Select Module dialog opens.
IMPORTANT
Click the Help button on the configuration dialog shown in this section if
you need assistance in selecting and setting the parameters.