Rockwell Automation 1738-AENTR, Series A 1734 POINT I/O and 1738 ArmorPOINT I/O 2 Port Ethernet/IP Adapter User Manual - Manual (Page 23)

Rockwell Automation Publication 1734-UM014B-EN-P - June 2013 15
Install Your Adapter Chapter 2
Wire the ArmorPOINT I/O Adapter
Wire the EtherNet/IP and auxiliary power connectors on the adapter as shown.
EtherNet/IP Connectors
Auxiliary Power Connector
(1)
Chapter Summary In this chapter, you learned how to install and wire your POINT I/O or
ArmorPOINT adapter module. The following chapter describes how to
configure your POINT I/O or ArmorPOINT I/O adapter module to
communicate on the EtherNet/IP network by providing an IP address, gateway
address, and Subnet mask.
IMPORTANT Analog modules have earth grounded metal rings. This should be
considered when choosing shielded cables and grounding techniques.
(1) Auxiliary power cable: standard cordset (single-ended), for example Allen-Bradley part number 889N-F4AFC-6F or 889N-R4AFC-
6F; or standard patchcord (double-ended), for example, Allen-Bradley part number 889N-F4AFNU-6F or 889N-F4AFNV-6F. Refer to
publication
M117-CA001A-EN-P for more information.
(view into connector)
Pin 1 - Tx +
Pin 2 - Rx +
Pin 3 - Tx -
Pin 4 - Rx -
M12 Female In Connector
43765
43587
Mini Style 4-Pin in Male Connector
(view into connector)
Pin 1 - User Power +
Pin 2 - Adapter Power +
Pin 3 - Adapter Power -
Pin 4 - User Power -