Add the point i/o adapter to the i/o configuration – Rockwell Automation 1738-AENTR, Series A 1734 POINT I/O and 1738 ArmorPOINT I/O 2 Port Ethernet/IP Adapter User Manual User Manual
Page 41
Advertising
Rockwell Automation Publication 1734-UM014B-EN-P - June 2013
33
Configure the Adapter for Direct Connection in RSLogix 5000 Software Chapter 4
Add the POINT I/O Adapter
to the I/O Configuration
Next, you must add the adapter as a child of the local 1756-ENBT module.
1. In the Project dialog, right-click the local 1756-ENBT module under the
I/O Configuration folder, and select New Module from the dialog.
The Select Module dialog opens.
2. Expand the Communications tree.
Advertising
This manual is related to the following products: