Rockwell Automation 1738-AENTR, Series A 1734 POINT I/O and 1738 ArmorPOINT I/O 2 Port Ethernet/IP Adapter User Manual - Manual (Page 69)

Rockwell Automation Publication 1734-UM014B-EN-P - June 2013 61
Configure the Adapter for Direct Connection and Rack Optimization in RSLogix 5000 Software Chapter 5
3. Click Set Project Path.
4. Click Download.
The Download dialog opens.
5. From the Download dialog, click Download.
The Downloading dialog displays the download progress.
Notice that the 1756-ENBT Bridge is now online.
If yellow triangles are present, see the following section.
Verify the Module
Chassis Size You have now built the I/O tree and the RSLogix 5000 software uses the chassis
size from the General tab of the adapter for the rack-optimized I/O connection.
Now you need to configure this new chassis size value into the adapter non-
volatile memory. This procedure synchronizes the chassis size value from the
RSLogix 5000 software into the adapter hardware. You must be online to
perform this procedure.
1. Verify that the RSLogix 5000 software is online.
2. Right-click the name of the adapter under I/O Configuration in the
Project dialog.
3. Select Properties.