Add the relay output module, Add the relay output module 36 – Rockwell Automation 1738-AENTR, Series A 1734 POINT I/O and 1738 ArmorPOINT I/O 2 Port Ethernet/IP Adapter User Manual User Manual
Page 44
36
Rockwell Automation Publication 1734-UM014B-EN-P - June 2013
Chapter 4 Configure the Adapter for Direct Connection in RSLogix 5000 Software
In this example, you add a 1734-OW2 relay output and a 1734-OV4E sink
output modules with standard configurations. Use these steps as a guide when
configuring different I/O modules for your system.
Add the Relay Output Module
1. Right-click the name of the remote adapter under the I/O Configuration
folder and select New Module.
The Select Module dialog opens.
2. Expand the Digital tree.
3. Select the 1734-OW2 relay output module from the list and click OK.
TIP
This example application uses I/O module default
configurations. For more information, refer to the
POINT I/O Selection Guide, publication