Rockwell Automation 1734-AENTR EtherNet/IP Network Configuration User Manual User Manual
Page 28
Advertising
28
Rockwell Automation Publication ENET-UM001L-EN-P - March 2014
Chapter 3 Configure an EtherNet/IP Communication Module to Operate on the Network
Set the Network IP Address with the Studio 5000 Environment
To use the Studio 5000 environment to set the communication module’s IP
address, follow these steps.
1. In the Controller Organizer, right-click the EtherNet/IP module and
choose Properties.
The Module Properties dialog box appears.
2. Click the Port Configuration tab.
3. In the IP Address field, type the IP address.
4. In the other fields, type the other network parameters, if needed.
5. Click Set.
6. Click OK.
IMPORTANT
The fields that appear vary from one EtherNet/IP
module to another.
Advertising
This manual is related to the following products: