Rockwell Automation 1734-AENTR EtherNet/IP Network Configuration User Manual - Manual (Page 82)

82 Rockwell Automation Publication ENET-UM001L-EN-P - March 2014
Chapter 6 Interlocking and Data Transfer between Controllers
5. If the target module is configured in the I/O Configuration folder of the
originating controller, click Browse to select the module or manually type
the path to the target module.
A manually typed path begins with the name of the local EtherNet/IP
communication module, the port the message exits (2 for EtherNet/IP),
and the IP address of the next module in the path, which could be the
target module.
EXAMPLE Communication path from a Logix5000 controller to a Logix5000 controller over
an EtherNet/IP network
washer, 2, 168.127.127.12, 1, 0
Ethernet Network
55
75 E
N
2T
55
75 E
N
2T
IP Address
168.127.127.12
Message
Where Indicates
Washer Name of the 1756-ENBT, 1756-EN2F, 1756-EN2T, 1756-EN2TR,
1756-EN2TXT, or 1756-EN3TR module
2 Ethernet port of the 1756-ENBT, 1756-EN2F, 1756-EN2T, 1756-
EN2TR, 1756-EN2TXT, or 1756-EN3TR module
168.127.127.12 IP address of the 1756-ENBT, 1756-EN2F, 1756-EN2T, 1756-EN2TR,
1756-EN2TXT, or 1756-EN3TR Module in the destination chassis
1 Backplane port of the 1756-ENBT, 1756-EN2F, 1756-EN2T, 1756-
EN2TR, 1756-EN2TXT, or 1756-EN3TR Module in the destination
chassis
0 Slot number of the destination controller