Rockwell Automation 1734-AENTR EtherNet/IP Network Configuration User Manual - Manual (Page 45)

Rockwell Automation Publication ENET-UM001L-EN-P - March 2014 45
Configure a Supervisor on a Device-level Ring Network Chapter 4
Complete the Physical
Connections of the Network After you configure and enable your ring supervisor nodes, you must complete
the physical connection of your new DLR network to make it complete and fully
functional.
This figure shows an example DLR network with all physical
connections complete.
Figure 5 - Example Device-level Ring Topology with All Connections Complete
Comm Adapter
MOD NET LINK 1 LINK 2
X 100 X 10
X 1
LINK 1
LINK 2
Last physical
connection is
made.