Rockwell Automation 1734-AENTR EtherNet/IP Network Configuration User Manual - Manual (Page 44)

44 Rockwell Automation Publication ENET-UM001L-EN-P - March 2014
Chapter 4 Configure a Supervisor on a Device-level Ring Network
5. Click the Network tab and check Enable Ring Supervisor.
Configuration takes effect immediately. You do not need to click Apply or
OK.
6. Click Advanced to configure supervisor-related parameters.
7. Configure desired supervisor-related parameters and click Set.
8. Click Close.
IMPORTANT For Beacon Interval, Beacon Timeout and Ring Protocol VLAN ID, we
recommend that you only use the default values.