Rockwell Automation 1734-AENTR EtherNet/IP Network Configuration User Manual User Manual
Page 38
Advertising
38
Rockwell Automation Publication ENET-UM001L-EN-P - March 2014
Chapter 4 Configure a Supervisor on a Device-level Ring Network
To configure the ring supervisor in the Studio 5000 environment, follow these
steps.
1. In the Controller Organizer, right-click 1756 Backplane and choose
New Module.
The Select Module dialog box appears.
2. Choose the module you wish to add and click OK.
Depending on the module type, the Select Major Revision dialog box
may appear. If the dialog box appears, choose the module’s major revision
and click OK.
Advertising
This manual is related to the following products: