Rockwell Automation 1734-AENTR EtherNet/IP Network Configuration User Manual - Manual (Page 49)

Rockwell Automation Publication ENET-UM001L-EN-P - March 2014 49
Control I/O Chapter 5
To build the I/O configuration for a typical distributed I/O network, follow
these steps.
1. Add the local communication module, that is, the bridge.
2. Add the remote adapter for the distributed I/O chassis or DIN rail.
3. Add the I/O module.
This graphic shows the consumer controller’s I/O configuration after distributed
I/O modules are added.
IMPORTANT
I/O is controlled on the same subnet and cannot be
processed via a router.