Rockwell Automation 1734-AENTR EtherNet/IP Network Configuration User Manual - Manual (Page 99)

Rockwell Automation Publication ENET-UM001L-EN-P - March 2014 99
Chapter
8
Communicate with PanelView Terminals
This chapter describes how a controller uses an EtherNet/IP communication
module to communicate with PanelView and PanelView Plus terminals over an
EtherNet/IP network.
Set Up the Hardware In this example, the controller in the local chassis shares data with an HMI
application on the EtherNet/IP network. This application could be running
these components:
• PanelView terminal
• PanelView Plus terminal
• Workstation running Factory Talk View software
• Workstation running a FactoryTalk Enterprise application, such as
FactoryTalk View Machine Edition or FactoryTalk View Supervisory
Edition
Figure 12 - Ethernet Communication with PanelView Terminal
Topic Page
Set Up the Hardware 99
Connections to PanelView Terminals 100
Add a PanelView Terminal 101
Organize Controller Data for a PanelView Terminal 105
Connections to FactoryTalk View Applications 106
Logix5575 Redundancy Module EtherNet/IP
PRI COM OK
ControlNet EtherNet/IP ControlNet
OK FORCE SD RUN
R UN REM PRO G
1 2
LNK1 LNK2 OK
10/100 BASE T
LNK NET OK
EtherNet/IP
LNK NET OK
Local Chassis Containing a
Logix5000 Controller with
an EtherNet/IP Connection
HMI with EtherNet/IP
Connectivity Data
EtherNet/IP Switch