Metrohm IC Net 2.2 - Manual (Page 219)

9.2 Sample queue control
IC Net 2.2 211
Amount Sample amount. If this value is different for
the calibration run (c) and the sample run
(s), the component concentrations of the
sample are calculated as follows:
C
s
= C
c
• Amount
s
/ Amount
c
Shut down system after the queue finishes
If this option is enabled, the system hard-
ware is shut down after the sample queue
has been finished (all pumps are switched
off), but it remains connected.
Close queue dialog window after the queue finishes
If this option is checked, the sample queue
overview table is closed at the end of the
last determination of the queue.
<Start> Start execution of the sample queue from
the first line with
Started = 0 .
<Pause> Stop execution of the sample queue after
the current determination has been fin-
ished.
<Edit> Open the sample queue editor program for
editing the sample queue table (see section
9.3).
<Close> Close the sample queue overview table.
9.2.2 Start sample queue
SAMPLE QUEUE OVERVIEW / Control / Start
Start execution of the sample queue from the first row with Started
= 0 . For each row, the sample-specific data are transferred to the
method of the current determination and the parameter Started is
set to 1 for this row.
A running sample queue can be interrupted with <Pause> . It can
be restarted with <Start> (with a running chromatogram only when
data acquisition is finished).
9.2.3 Pause sample queue
SAMPLE QUEUE OVERVIEW / Control / Pause
Interrupt execution of the sample queue after the current determi-
nation has been finished.
A running sample queue can be interrupted with
<Pause> . When
the current determination has been finished, the sample queue
can be restarted with
<Start> or stopped with Control / Stop deter-
mination in the SYSTEM window.