Metrohm IC Net 2.2 - Manual (Page 52)

5 Interfaces
IC Net 2.2 44
Event command (2 nd column)
Setting the event output lines 1 … 7.
Selection:
0 (line off, inactive, open)
1 (line on, active, 0 V)
p (pulse, pulse length 150 ms)
* (leave line in current status)
For entry of the first value, enter 1 , 0 , p or * .
For entry of the other values, move the cur-
sor in front of the value to be changed and
enter
1 , 0 , p or * .
<Add> Add new remote command.
<Delete> Delete selected remote command.
<Activate> Activate the defined remote commands for
insertion into the time program.
Events setup
The
Events setup
tab of the
762 System [#]
window contains the
startup values for the seven event output lines of system 1 or
system 2 of the 762 IC Interface. These startup values are sent
each time the system is connected or a determination is started.
Each event output line can be set to the following values:
0 Line off, inactive (open)
1 Line on, active (0 V)
For technical information see 762 Instructions for Use.