Kontron CG2100 Carrier Grade Server - Manual (Page 3)

www.kontron.com
www.kontron.com
Re-Installing the Processor Air Duct ..................................... 26
3.3 Internal System Components Configuration and Installation Procedures ........ 26
Configuring Memory DIMMs ................................................. 26
Supported Memory ......................................................... 27
Publishing System Memory ................................................. 27
Memory Map and Population Rules .......................................... 27
Memory RAS ............................................................... 28
Memory Upgrade Rules ..................................................... 30
Installing Memory DIMMs .................................................. 31
Replacing or Removing Memory DIMMs ....................................... 32
Adding or Replacing a Processor .......................................... 32
Inserting the Heat Sink .................................................. 35
Configuring Jumpers on the Server Board .................................. 36
4 Optional Component Installation Procedures ...... 38
4.1 Before You Begin ............................................................ 38
Tools and Supplies Needed ................................................ 38
System References ........................................................ 38
Cable Routing Reference .................................................. 38
4.2 Installing or Replacing Hard Disk Drives .................................... 40
Removing an HDD Carrier from the Chassis ................................. 40
Installing a Hard Drive in a Carrier ..................................... 41
4.3 Installing a SAS/SATA Control Module ........................................ 42
4.4 Installing a Hardware RAID Module ........................................... 45
4.5 Installing a RAID Intelligent Battery Backup Unit (IBBU) .................... 46
4.6 Adding a Second Power Supply Module ......................................... 47
4.7 Installing a PCI Riser Card ................................................. 48
4.8 Installing PCI Add-in Cards ................................................. 49
4.9 Installing a Personality Module ............................................. 50
4.10 Installing a Remote Management Module ....................................... 51
4.11 Installing an SD Flash Module ............................................... 52
4.12 Installing a USB Solid-State Drive .......................................... 55
Installing a Solid-State Drive on the Front Panel Board .................. 55
Installing a Solid-State Drive on the Server Board ....................... 56
4.13 Installing the Server into a Rack ........................................... 57
Connecting the Power Cord ................................................ 57
Equipment Rack Precautions ............................................... 57
5 Server Component Replacements ................... 59
5.1 Before You Begin ............................................................ 59