Installing a hard drive in a carrier – Kontron CG2100 Carrier Grade Server User Manual
Page 42
41
Installing a Hard Drive in a Carrier
1.
If a drive is already installed (that is, if you are replacing the drive), remove it
by unfastening the four screws that attach the drive to the drive carrier. (Figure
27, “A”)
Set the screws aside for use with the new drive.
2.
Lift the drive out of the carrier. (“B”)
Figure 27. Removing a Hard Drive
3.
Install the new drive in the drive carrier (Figure 28, “A”) and secure the drive
with the four screws that come with the carrier. (“B”)
Figure 28. Installing a Hard Drive
4.
With the drive carrier locking lever fully open, push the hard drive carrier into
the drive bay in the chassis until it stops. (Figure 29 “A”)
5.
Press the locking lever until it snaps shut and secures the drive in the bay.