Kontron CG2100 Carrier Grade Server - Manual (Page 77)

76
Figure 68. Removing the Backplane Board
Installing the New SAS/SATA Backplane Board
NOTE: Make sure the six-slot HDD backplane has top and bottom insulators on the rear
side of the board.
1. Slide the backplane board part way into place behind the HDD bay assembly, making
sure the board fits securely between the edge of the HDD bay assembly and the guide
pins on the HDD bay assembly. (Figure 69, “A” and “B”)
Figure 69. Installing the Backplane Board
2. Connect the power cable into the front of the backplane board, leaving the board
only partially inserted. (“C”)
3. Make sure the metal clips on the bottom of the backplane board line up with the HDD
bay assemble flange. (Figure 70, “A”)
Press the backplane board all the way down so the metal clips capture the flange.
(“C”)