Kontron CG2100 Carrier Grade Server - Manual (Page 44)

43
Figure 31. Installing the SAS/SATA Control Module in the Bracket
5. Line the SAS/SATA control module and bracket up close to the SAS/SATA backplane
board and insert the SAS/SATA control module card edge into the edge connector on
the backplane board. (Figure 32, “A” and “B”)
Figure 32 Installing the SAS/SATA Control Module
6. Fasten the bracket to the SAS/SATA backplane hold-down plate with one screw. (“C”)
7. Attach the flex circuit cable (Figure 33, “A”) to the connector on the SAS/SATA
control module (“B”).