Kontron CG2100 Carrier Grade Server - Manual (Page 53)

52
Figure 45. Removing the GCM Port Filler Panel
5. Attach the bracket to the top of the module with the two smaller screws in the
package. (Figure 46, “A”)
6. Attach one end of the cable to the bottom of the module and the other end to the
connector on the server board. (“B”)
7. Line the module up with rear panel of the chassis so that the NIC is positioned in
the connector slot.
Use the two larger screws in the package to fasten the bracket to the rear panel
over the NIC. (“C”)
Figure 46. Installing the GCM NIC Module
8. If this is the last task you are performing, replace the processor air duct, the
riser card assembly, and the back chassis cover. Reconnect all the external devices
and plug in the power cord(s).
4.11 Installing an SD Flash Module
The CG2100 server SD flash module supports the use of two SD flash memory card. The
SD flash module package includes the board, a bracket, and a USB cable. The server
chassis comes with a filler panel on the front panel where the optional SD flash
module bracket is installed.
Note: Check the bracket to be sure all eight EMI shield clips are installed.