Rice Lake iQUBE2 Digital Diagnostic Junction Box - Manual (Page 28)

24 iQUBE 2 Installation Manual
Level 5 Submenus
BIT 1 - BIT 4 OFF
ZERO
TARE
NT/GRS
UNITS
PRINT
CLRCN
CLRTAR
SETPNT
CELHLTH
HOSTCTRL Specifies the function of each digital I/O bit.
•OFF indicates that the bit is not configured.
•ZERO, TARE, NT/GRS, UNITS, and PRINT provide the same functions as the five
major front panel keys.
•CLRCN resets the consecutive number.
•CLRTAR clears the current tare for the active scale.
•SETPNT designates the bit as a free-running setpoint within the iQUBE 2
.
•CELHLTH designates the bit to provide cell health information.
•HOSTCTRL gives the host control over the bit’s function.
Revolution III should be used to fully configure these parameters.
IQCOM1 ADDRESS
RSPDLY
BAUD
EOLDLY Contains parameters for standard communications options. See parameter descriptions
under Level 6 Submenus.
A1-4
B1-4
C1-4
D1-4 CAPACITY
SENSTV
ID CAPACITY enters the load cell’s capacity.
SENSTV enters the load cell’s actual or nominal millivolt/volt sensitivity.
ID specifies the load cell ID.
Level 6 Submenus
ADDRESS 0
number Specifies the RS-485 address
RS-485 communications can be specified for Port 4, and for odd-
numbered expansion ports 5 and higher.
RSPDLY 2
number Response delay (in milliseconds). Used for RS-422 2-wire communication.
Minimum value = 2.
BAUD 115200
230400
450000
460800
9600
19200
38400
57600 Baud rate. Selects the transmission speed for the port.
EOLDLY 0
0-255 End-of-line delay. Sets the delay period, in 0.1-second intervals, from when a formatted line
is terminated to the beginning of the next formatted serial output. Value specified must be in
the range 0-255, in tenths of a second (10 = 1 second).
SERIAL Menu (PORTn, iQUBE Submenu)
Parameter Choices Description
Table 3-1. Serial M enu, PORTn, iQUBE Submenu Parameters
Note
Note