Rice Lake iQUBE2 Digital Diagnostic Junction Box - Manual (Page 48)

44 iQUBE 2 Installation Manual
Command
c = load cell number Description Values
LCc.ID Load cell ID Load Cell A1, load_cell_ID (16 characters,
maximum)
LCc.SRLNUM Load cell serial number (16 characters, maximum)
LCc.CAPACITY Load cell capacity 0-1,000,000
LCc.SENS Load cell sensitivity 0.0001–9.9999 (mV/V)
LCc.TRIM Load cell trim factor 0–5.0000
LCc.ZERO Load cell zero counts value 0–16777215
LCc.COUNTS Read A/D count —
LCc.CDMV Read corrected deadload mV value —
LCc.RMV Read raw mV value —
LCc.CMV Read corrected mV value —
LCc.WEIGHT Read calibrated weight value —
LCx.SAMPLEn Uploads/Downloads calibration values for the
given (n)
Cal-Match calibration step (
-16777215–16777215
LCx.SAMPLE Uploads/Downloads calibration values for all
calibration steps -16777215–16777215
Table 5-6. iQUBE 2 Load Cell Commands
Command
s = scale number Description Values
SCs.CALTYPE Calibration type SECMATCH, CORNERMATCH, 2-
POINT
Calibration commands for CALTYPE = SECMATCH, CORNERMATCH
SCs.CAL0 Zero calibration —
SCs.CALn Calibration step n Assign calibration step number (1–
16, maximum) for each load cell in
CORNERMATCH calibration, for
each section pair (1–8, maximum) in
SECTIONMATCH calibration
SCs.NORM Normalize platform Final calibration step after
completing SCs.CAL0 through
SCs.CALn
Calibration commands for CALTYPE = SINGLE, MULTI
SCs.WZERO Zero calibration —
SCs.WVAL Platform test weight value 0–9999999
SCs.WSPAN Platform span calibration 0–16777215
Other calibration commands
SCs.LC.CD Set deadload coefficient 0–16777215
SCs.LC.CW Set span coefficient 0–16777215
SCs.LC.CZ Set temporary zero 0–16777215
SCs.REZERO Rezero 0–16777215
SCs.LASTZERO Last zero 0–16777215
SCs.WLIN.W1–SCs.WLIN.W5 Raw count value for linearization points 1–5 0–16777215
SCs.WLIN.V1–SCs.WLIN.V5 Test weight value for linearization points 1–5 0.000001–9999999
SCs.WLIN.C1–SCs.WLIN.C5 Calibrate linearization points 1–5 —
SCs.CALSPAN Platform span calibration on Cal-Match scale types
Table 5-7. iQUBE 2 Calibration Commands