Rice Lake iQUBE2 Digital Diagnostic Junction Box - Manual (Page 49)

Serial Commands 45
Command
p = port number Description Values
COMMOPTS Lists any option cards installed DEFAULT=7, Fiber=6, Ethernet=5, WiPort=4,
Reserved=3, USB=2, RS232/485=1
COMp.ADDRESS Port RS-485 address 0=OFF, 1–254
COMp.BAUD Port baud rate 9600, 19200, 38400, 57600, 115200,
230400, 450000, 460800
COMp.BITS Port data bits and parity 1, 2
COMp.SBITS Port stop bits 1, 2
COMp.TERMIN Port termination character CR/LF, CR, NONE
COMp.EOLDLY Port end-of-line delay 0–25 (0.1-second intervals)
COMp.ECHO Port character echo ON, OFF
COMp.CHECK Port cyclical redundancy check (CRC) OFF, CRC
COMp.STRM.CHECK Append data integrity check to streamed data OFF, CKSUM, ACKSUM, CRC, ACRC
See NOTE below
COMp.STRM.POST Post-fix character to streaming frame format 0 (none), last_character (ASCII decimal value)
COMp.STRM.PREF Pre-fix character to streaming frame format 0 (none), first_character (ASCII decimal value)
COMp.P.CHECK Append data integrity check to polled data OFF, CKSUM, ACKSUM, CRC, ACRC
See NOTE below
COMp.P.POST Post-fix character to polling frame format 0 (none), last_character (ASCII decimal value)
COMp.P.PREF Pre-fix character to polling frame format 0 (none), first_character (ASCII decimal value)
NOTE: Values for the COMp.STRM.CHECK and COMp.P.CHECK commands are as follows:
OFF No check data appended
CKSUM Sum of characters appended in binary (2 bytes)
ACKSUM Sum of characters appended in hexadecimal ASCII (4 bytes)
CRC CRC data appended in binary (2 bytes)
ACRC CRC data appended in hexadecimal ASCII (4 bytes)
Table 5-8. iQUBE 2 Serial Port Commands
Command
n = setpoint number Description Values
SPn.ENABLE Setpoint enable OFF, ON
SPn.KIND Setpoint kind GROSS, NET
SPn.VALUE Setpoint value –999999 – 999999
SPn.TRIP Setpoint trip HIGHER, LOWER, INBAND, OUTBAND
SPn.BNDVAL Setpoint band value 0–999999
SPn.HYSTER Setpoint hysteresis 0–999999
SPn.DIGOUT Setpoint digital output 1, 2, 3, 4
Table 5-9. iQUBE 2 Setpoint Commands