Hardy HI 6600 Series Modular Sensor System - Manual (Page 107)

HI 6600 Series Modular Sensor System User Guide
Page | 107
Parameters
Parameters are the first listed hyper- link at the base of the
Diagnostics page. Click that link to display the Parameters
page. Note the scroll bar on the right of the list.
The steps below explain how you can duplicate the
configuration of one HI 6610 or HI 6600 to use in
configuring another HI 6610 or HI 6600 for sending a copy
of your parameters to [email protected]
To copy the parameters:
1) Right click in the parameter list.
2) Click Select All.
3) Right click again.
4) Click Copy.
To paste the parameter configuration into the instrument you want to configure, or into a text file for storage:
1) Enter the IP address of that instrument into a Web browser to display its Home page.
2) Select Operation, then Diagnostics, then Parameters, as described above.
3) Right click in the Parameter list.
4) Click Select All.
5) Right click again in the Parameter List.
6) Click on Paste to replace the existing or default parameter settings with the parameters settings of the
instrument you copied. Only the past setting from a text file will work---you can not paste from a word
processing program.
7) Click the Save button. You now have an exact duplicate of the pre-configured instrument.
If you need to make any modifications to the parameter settings go to Chapter 4, Configuration, for more
instructions.