Hardy HI 6600 Series Modular Sensor System User Manual
Page 51
HI 6600 Series Modular Sensor System User Guide
Page | 51
Windows PC Configuration: Windows 2000
1) After starting your computer, click the Start button.
2) Click on Settings > Control Panel to display the Windows
Control
Panel.
3) Click the Network icon to display the Network dialog.
4) Click on TCP/IP; then click the Properties button to open
the
TCP/IP Properties dialog.
5) Click the IP Address tab.
6)
If the ‘Use the Following IP Address’ box is already checked, write down the displayed IP Address and jump to the
Direct Connect Configuration – HI 6600 section below.
7)
Click the ‘Specify an IP Address’ check box; then enter the following into the TCP/IP Properties dialog
.
IP Address = 192.168.0.100
Subnet Mask = 255.255.255.000
8) Select OK on the TCP/IP Properties dialog. The computer is now fully configured.
9) To return the PC to the original network settings, return to the ‘Internet Properties (TCP/IP) dialog, select ‘Obtain an IP
address automatically,’ and click OK.
Windows XP
1) After starting your computer, click Start.and then Control Panel.
2) Click on Settings > Network Connections.
3) Right click on ‘Local Area Connection’ and select Properties.
4) Click on Internet Protocol (TCP/IP) and click on the Properties button to open the Internet Properties
(TCP/IP) Properties dialog.
5) If the ‘Use the Following IP Address’ box is already checked, write down the displayed IP Address and
jump to the Direct Connect Configuration – HI 6600 section below.
6) Click the ‘Use the Following IP Address’ check box; then enter the following into the TCP/IP Properties
dialog.
IP Address = 192.168.0.100
Subnet Mask = 255.255.255.000
7) Select OK on the TCP/IP Properties dialog box. The computer is now fully configured.
8) To return the computer to the original network settings, return to the ‘Internet Properties (TCP/IP) dialog, select
‘Obtain an IP address automatically,’ and click OK.
Windows 7
1) After starting your computer, click the Start button.
2) Click on Control Panel to display the Windows Control Panel.
3) C lick on Network; then click Internet
4) Click on Network Sharing Center.