Hardy HI 6600 Series Modular Sensor System - Manual (Page 47)

HI 6600 Series Modular Sensor System User Guide
Page | 47
Chapter 6
Network Communications
• • • • • •
Chapter Six contains step-by-step instructions for configuring the HI 6600 Hardy Gateway Module for communications
with external networks, often interfacing with a PLC, DCS or PC network. We recommend reading these procedures
because having a correct configuration is necessary to ensure trouble-free operation.
This chapter also explains how to either configure the HI 6600 series instrument from the Webserver over a standard
Ethernet network. The features of the HI 6600 series instrument operate the same way in either case. You must use the
Web interface to configure units that do not have an optional display.
Before operating the HI 6610 Weight Processor, make sure that:
Power and load point cables are properly installed and in working order.
Communication cables are properly installed and in working order. The following parameters are used to setup instrument
communication
 EtherNet/IP (Available on HI 6600-EIP Models only)
 Ethernet TCP/IP /UDP
o DHCP
o Fixed IP
o Dynamic IP
o Mask Address
o Gateway Address
o DNS Server
 Ethernet UDP
 Hardy Port
 Modbus TCP
 Modbus-RTU
o Slave Address
o Baud Rate
o Parity
 Profibus-DP (Available on HI 6600-PB Models only)
 Scoreboard
 USB
o Restore
o Save