Hardy HI 6600 Series Modular Sensor System - Manual (Page 16)

HI 6600 Series Modular Sensor System User Guide
Page | 16
2) Check to see that everything in the package matches the bill of lading.
3) If items are missing or you have any questions, contact Customer Service at:
Hardy Process Solutions 9440 Carroll Park Drive San Diego, CA 92121
Phone: (800) 821-5831
International: (858) 292-2710
FAX:
(858) 278-6700
Web Site: http//www.hardysolutions.com
E-Mail: [email protected]
Record the model number and serial number of the HI 6600 series instrument. Store them in a convenient, secure location
for reference when contacting Hardy Customer Service Department or to buy parts or firmware upgrades.
Tool List
To install the HI 6600 series the following tools will be required.
 Jewelers screw driver (to make and modify cable assemblies)
 10-50 mm Unibit (for optional display installation)
 Drill with 5mm drill bit (for optional display installation)
 8 mm nut wrench or socket (for Optional Display)
Installing the HI 6610 Modules
Before getting started, take the following precautions:
 Wear an approved wrist-strap grounding device when handling the instrument.
 Touch a grounded object or surface to rid yourself of any electrostatic discharged prior to handling the
instrument.
 Handle the instrument from the bezel in front away from the connector. Do not touch the connector pins.
 Do not install the instrument right next to an AC power source or high voltage DC equipment
 Route all the low voltage cables away from high voltage cables
AVERTISSEMENT – Les décharges électrostatiques peuvent endommager les
composants semi-conducteurs dans le module. NE TOUCHEZ PAS les broches du
connecteur.
WARNING - Electrostatic discharge may damage semiconductor components in
the module. DO NOT TOUCH THE CONNECTOR PINS.