Hardy HI 6600 Series Modular Sensor System - Manual (Page 19)

HI 6600 Series Modular Sensor System User Guide
Page | 19
Cabling the Units Together
Once the units are all placed on a DIN rail, connect them together in a series using the RJ45 ports on the bottom of the
units and Cat5e cable.
The Cat5e cabling carries communications between the modules and distributes power from the Hardy Gateway Module
to the Weigh Processing Modules.
Redundant DC power may also be supplied individually to each Weight Processing Module via the DC power input
terminal located on the bottom of the module. DC power supplied to individual Weight Processing Modules is isolated
and not distributed to other modules on the system.
At minimum, DC power must be supplied to the Gateway Module.
The maximum distance between the first and last module on a system is 500 feet (150 meters).
DC Power Input
AVERTISSEMENT – Assurez-vous que la source d’alimentation ne dépasse pas
240 V. L’utilisation d’un mauvaise voltage peut résulter en dégâts matériels
et/ou des risques de blessures.
WARNING - Do not operate with incorrect line voltage. To do so will result in
property damage and/or personal injury. Make sure that the power source does
not exceed 24 VDC.