Scrnaspect, Projector user commands, Format – Canon SX 50 User Manual
Page 102: Parameter, Response, Description, Example, Commands supported, Environment
Projector User Commands
- 96 -
Revision History / Date
Changes
Revised by
Approved by
SCRNASPECT
Screen aspect setting
Format
SCRNASPECT=<Screen aspect setting parameter:ID>
Parameter
<Screen aspect setting parameter:ID>
4:3 4:3
display
16:9 16:9
display
16:9_DIS
16:9 Digital Image Shift
The parameters which can be set at any given point in time can be obtained using the RANGE
command. For details, refer to the RANGE command.
Response
"i:OK" is returned if the parameter was set properly.
For details on other responses, refer to the "Error List".
Description
This sets the screen aspect.
(1) It can be executed whenever the projector is in the power-on status.
(2) A “busy” response is given while the zoom or focus lens is being driven.
(Refer to the ZCONTDRV command and FCONTDRV command.)
(3) This command is the same as the menu functions in the table below.
Model
Menu
SX7 Mark II
[Display settings] - [Screen aspect]
(4) The GET command can be used to retrieve the current screen aspect.
For details, refer to the GET command.
Example
Setting
> SCRNASPECT=16:9
This sets the screen aspect to 16:9.
> i:OK
Reference
> GET SCRNASPECT or ?SCRNASPECT
This retrieves the screen aspect.
< g:SCRNASPECT=16:9_DIS
Acquisition of parameters which can be set
> RANGE SCRNASPECT
< r:SCRNASPECT=I, 4:3, 16:9, 16:9_DIS
* Commands are indicated by ">", and responses are indicated by "<".
Commands supported
This defines the environments that support the command (power supply state, input signal state).
SX50
01.00**
SX6
01.01**
SX60
01.01**
X600
01.01**
SX7
01.01**
X700
01.01**
SX7 Mark II
01.02**
x x x x x x O
* When a command is not supported, "e:0002 INVALID_COMMAND" is returned.
Environment
This defines the environments that support the command (power supply state, input signal state).
Power
Input
Mode
Model
OFF ON PM
D-RGB A-RGB1 A-RGB2 COMP
Video S-Video D-Video SCART None Remote Local
Remarks
SX50 -
-
- - - - - - - - - - - -
SX6, SX60,
X600
-
-
- - - - - - - - - - - -
SX7,
X700
-
-
- - - - - - - - - - - -
SX7 Mark II x
O
x
O
O
O
O
O
O
O
O
O
O
O
* If a state is not supported, "NOT_POWER_SUPPLIED" is returned with the Err response.
* When the power supply state is in the process of switching, an "i:BUSY" reply may be sent.
Setting