Remote, Projector user commands, Format – Canon SX 50 User Manual
Page 94: Response, Description, Example, Commands supported, Environment
Projector User Commands
- 88 -
Revision History / Date
Changes
Revised by
Approved by
REMOTE
Switch to Remote mode
Format
REMOTE
Response
"i:OK" is returned mode was switched properly.
For details on other responses, refer to the "Error List".
Description
This switches to Remote mode.
(1) During Remote mode, all buttons are disabled except for the front panel and remote control POWER
button.
(2) This command can be used in any projector mode.
However, zoom or focus lens drive stops if the zoom or focus lens is being driven.
(Refer to the ZCONTDRV command and FCONTDRV command.)
(3) If, in the power management standby status, the "REMOTE" command was received and operation was
switched to the remote mode, the "power-on" (lamp lighted) status is established unconditionally
(4) With the SX50, the setting, control and reference commands except for RC and MAIN can be used only in
the remote mode.
(RC and MAIN can be used only in the "local mode.")
With the SX6, SX60, X600, SX7, X700, SX7 Mark II and , there are several setting, control and reference
commands which can be used in the local mode.
(Refer to the LOCAL command.)
(5) When this command is executed, all the statuses and settings listed below are cleared.
・
Digital zoom
・
Presentation timer display
・
Spotlight display
・
Screen temporary off (NoShow)
・
Freeze image (Freeze)
・
Command now being executed (except during "user image registration")
・
Focusing, zooming underway (with the SX6, SX60, X600, SX7, X700, SX7 Mark II and )
(6) "Guide display" is not cleared by the transfer of operation to the remote mode. If necessary, clear the
display using the GUIDE command.
(7) The GET command can be used to retrieve the current mode.
Example
Mode switching
> REMOTE
< i:OK
Mode viewing
> GET MODE or ?MODE
< g:MODE=LOCAL
* Commands are indicated by ">", and responses are indicated by "<".
Commands supported
This defines the environments that support the command (power supply state, input signal state).
SX50
01.00**
SX6
01.01**
SX60
01.01**
X600
01.01**
SX7
01.01**
X700
01.01**
SX7 Mark II
01.02**
O O O O O O O
Environment
This defines the environments that support the command (power supply state, input signal state).
Power
Input
Mode
Model
OFF ON PM
D-RGB A-RGB1 A-RGB2 COMP
Video S-Video D-Video SCART None Remote Local
Remarks
SX50 O
O
O O O
O
O O
O
- - O O O
SX6, SX60,
X600
O
O O
O
O
O
O
O
O
O
O
O
O
O
SX7, X700 O
O
O
O
O
O
O
O
O
O
O
O
O
O
SX7 Mark II O
O
O
O
O
O
O
O
O
O
O
O
O
O
Mode