Canon SX 50 - Manual (Page 52)

Projector User Commands
- 46 -
Revision History / Date Changes Revised by Approved by
HPIX/VPIX
Horizontal/Vertical resolution adjustment
Format
HPIX=<Horizontal resolution:Number>
VPIX=<Vertical resolution:Number>
Parameter
<Horizontal resolution:Number>
<Vertical resolution:Number>
The parameters which can be set at any given point in time can be obtained using the RANGE
command. For details, refer to the RANGE command.
Response
"i:OK" is returned if the parameter was set properly.
For details on other responses, refer to the "Error List".
Description
This adjusts the horizontal and vertical resolution (number of dots) on the screen.
(1) For models other than SX7 Mark II: It can be executed when the projector is in both the remote mode and
power-on status at the same time.
For SX7 Mark II: It can be executed whenever the projector is in the power-on status.
(2) A “busy” response is given while the zoom or focus lens is being driven.
(Refer to the ZCONTDRV command and FCONTDRV command.)
(3) It may not be possible to execute the command with some input signals.
(4) This command has the same function as the buttons listed in the table below.
Model Menu
SX50
[Display settings] - [Input signal settings] - [No. of horizontal display dots]
[Display settings] - [Input signal settings] - [No. of vertical display dots]
SX6, SX60, X600, SX7, X700,
SX7 Mark II [Display settings] - [Input signal settings] - [No. of horizontal dots]
[Display settings] - [Input signal settings] - [No. of vertical dots]
(5) The GET command can be used to retrieve the current horizontal and vertical resolution.
For details, refer to the GET command.
Example
Setting
> HPIX=1024 This sets the horizontal resolution to 1024.
< i:OK
Reference
> GET VPIX or ?VPIX This retrieves the vertical resolution.
< g:VPIX= 864
Obtain settable parameter range (Min, Max)
> RANGE VPIX
< r:VPIX=N, 0, 1000 Any value from 0 to 1000 can be set for the horizontal resolution.
* Commands are indicated by ">", and responses are indicated by "<".
Commands supported
This defines the environments that support the command (power supply state, input signal state).
SX50
01.00**
SX6
01.01**
SX60
01.01**
X600
01.01**
SX7
01.01**
X700
01.01**
SX7 Mark II
01.02**
O O O O O O O
Setting