Canon SX 50 - Manual (Page 183)

Projector User Commands
- 177 -
Revision History / Date Changes Revised by Approved by
RANGE ACADJUST
Advanced color adjustment option request
Format
RANGE□ACADJUST
Response
r:ACADJUST=I, <Setting option 1>, <Setting option 2>, …, <Setting option n>
For details on other responses, refer to the "Error List".
Description
This command is used to inquire about the parameter options which enable the advanced color
adjustment to be set.
(1) Inquiry can be made when the projector is in both the remote mode and power-on status at the same time.
(2) A “busy” response is given while the zoom or focus lens is being driven.
(Refer to the ZCONTDRV command and FCONTDRV command.)
(3) The advanced color adjustment can be set by the ACADJUST command.
Example
> RANGE ACADJUST
< r:ACADJUST=I, NOCORRECT, MEM_L, MEM_M, MEM_H, 6AX
* Commands are indicated by ">", and responses are indicated by "<".
Commands supported
This defines the environments that support the command (power supply state, input signal state).
SX50
01.00**
SX6
01.01**
SX60
01.01**
X600
01.01**
SX7
01.01**
X700
01.01**
SX7 Mark II
01.02**
O x x x x x x
* When a command is not supported, "e:000A INVALID_PARAMETER" is returned.
Environment
This defines the environments that support the command (power supply state, input signal state).
Power Input Mode
Model
OFF ON PM D-RGB A-RGB1 A-RGB2 COMP Video S-Video D-Video SCART None Remote Local
Remarks
SX50 x O x x x x O O O - - O O x
SX6, SX60,
X600
- - - - - - - - - - - - - -
SX7, X700 - - - - - - - - - - - - - -
SX7 Mark II - - - - - - - - - - - - - -
* If a state is not supported, "INVALID_MODE" or "NOT_POWER_SUPPLIED" is returned with the Err response.
* When the power supply state is in the process of switching, an "i:BUSY" reply may be sent.
Reference