Get mute, Projector user commands, Format – Canon SX 50 User Manual
Page 154: Response, Description, Example, Commands supported, Environment
Projector User Commands
- 148 -
Revision History / Date
Changes
Revised by
Approved by
GET MUTE
Mute control setting inquiry
Format
GET□MUTE
?△MUTE
Response
g:MUTE=<Setting:ID>
<Setting:ID>
ON
This turns off the audio/beep sound.
OFF
This returns the audio/beep sound to its original setting.
For details on other responses, refer to the "Error List".
Description
This command is used to inquire about the current mute control setting.
(1) For models other than SX7 Mark II: Inquiry can be made when the projector is in both the remote mode
and power-on status at the same time.
For SX7 Mark II: Inquiry can be made whenever the projector is in the power-on status.
(2) A “busy” response is given while the zoom or focus lens is being driven.
(Refer to the ZCONTDRV command and FCONTDRV command.)
(3) Mute control can be set by the MUTE command.
Example
> GET MUTE or ? MUTE
< g:MUTE=ON
* Commands are indicated by ">", and responses are indicated by "<".
Commands supported
This defines the environments that support the command (power supply state, input signal state).
SX50
01.00**
SX6
01.01**
SX60
01.01**
X600
01.01**
SX7
01.01**
X700
01.01**
SX7 Mark II
01.02**
O O O O O O O
Environment
This defines the environments that support the command (power supply state, input signal state).
Power
Input
Mode
Model
OFF ON PM
D-RGB A-RGB1 A-RGB2 COMP
Video S-Video D-Video SCART None Remote Local
Remarks
SX50 x
O
x O O
O
O O
O
- - O O x
SX6, SX60,
X600
x
O
x
O
O
O
O
O
O
O
O
O
O
x
SX7, X700
x
O
x
O
O
O
O
O
O
O
O
O
O
x
SX7 Mark II x
O
x
O
O
O
O
O
O
O
O
O
O
O
* If a state is not supported, "INVALID_MODE" or "NOT_POWER_SUPPLIED" is returned with the Err response.
* When the power supply state is in the process of switching, an "i:BUSY" reply may be sent.
Reference