Get dpon, Projector user commands, Format – Canon SX 50 User Manual
Page 132: Response, Description, Example, Commands supported, Environment
Projector User Commands
- 126 -
Revision History / Date
Changes
Revised by
Approved by
GET DPON
Direct power-on setting inquiry
Format
GET□DPON
?△DPON
Response
g:DPON=<Setting:ID>
<Setting:ID>
ON
This sets direct power-on to ON.
OFF
This sets direct power-on to OFF.
For details on other responses, refer to the "Error List".
Description
This command is used to inquire about the current direct power-on setting.
(1) For models other than SX7 Mark II: Inquiry can be made when the projector is in both the remote mode
and power-on status at the same time.
For SX7 Mark II: Inquiry can be made whenever the projector is in the power-on status.
(2) A “busy” response is given while the zoom or focus lens is being driven.
(Refer to the ZCONTDRV command and FCONTDRV command.)
(3) Direct power-on can be set using the DPON command.
Example
> GET DPON or ? DPON
< g:DPON=OFF
* Commands are indicated by ">", and responses are indicated by "<".
Commands supported
This defines the environments that support the command (power supply state, input signal state).
SX50
01.00**
SX6
01.01**
SX60
01.01**
X600
01.01**
SX7
01.01**
X700
01.01**
SX7 Mark II
01.02**
x O O O O O O
* When a command is not supported, "e:000A INVALID_PARAMETER" is returned.
Environment
This defines the environments that support the command (power supply state, input signal state).
Power
Input
Mode
Model
OFF ON PM
D-RGB A-RGB1 A-RGB2 COMP
Video S-Video D-Video SCART None Remote Local
Remarks
SX50 -
-
- - - - - - - - - - - -
SX6, SX60,
X600
x
O
x
O
O
O
O
O
O
O
O
O
O
x
SX7, X700
x
O
x
O
O
O
O
O
O
O
O
O
O
x
SX7 Mark II x
O
x
O
O
O
O
O
O
O
O
O
O
O
* If a state is not supported, "INVALID_MODE" or "NOT_POWER_SUPPLIED" is returned with the Err response.
* When the power supply state is in the process of switching, an "i:BUSY" reply may be sent.
Reference