Canon SX 50 - Manual (Page 180)

Projector User Commands
- 174 -
Revision History / Date Changes Revised by Approved by
Parameter Meaning
BVOL Beep sound setting status
IMAGEFLIP Flip display status
PMM Power management
PJON Display screen at startup setting
NOSIG Display screen when there are no signals setting
NOSHOW Display screen when nothing shown
LOGOPOS User image position
LANG Language
LAMP Lamp output
TERMINAL Terminal setting
KEYLOCK Key lock
RCCH Remote control Ch
DVRANGE Digital video setting
GUIDE Guide display setting
DPON Direct power-on setting
LEDILLUMINATE LED display setting
ZSTEPDRV Zoom step control
ZCONTDRV Zoom continuous control
FSTEPDRV Focus step control
FCONTDRV Focus continuous control
Response
Responses are made in the formats below for each parameter.
<Parameter name>=<Type>, <Setting range>
<Type>
I ID
N Number
<Setting range>
The definition of <Setting range> varies depending on the type.
1. When the type is I (ID)
<Setting range>: = <Setting option 1>, <Setting option 2>, <Setting option 3>,
<Setting option 4>, …, <Setting option N>
2. When the type is N (Number)
<Setting range>: = <Setting option 1 minimum value>, <Setting option 1 maximum value>,
<Setting option 2 minimum value>, <Setting option 2 maximum value>,
…,<Setting option N minimum value>, <Setting option N maximum value>
Description
This retrieves the setting range of each parameter.
(1) The setting ranges of the setting or control command parameters may differ depending on the projector
status (input, display mode, etc.).
(2) To ensure reliability, request the setting ranges before sending the setting or control commands.
(Once the setting ranges have been obtained, the setting or control commands can be executed properly)
(3) For details, refer to the descriptions of each command.