Canon SX 50 - Manual (Page 113)

Projector User Commands
- 107 -
Revision History / Date Changes Revised by Approved by
WBRGB
Screen color correction (ADJUST)
Format
WBRGB=<R adjustment value:Number>▽<G adjustment value:Number>▽<B adjustment value:Number>
Parameter
<R adjustment value:Number>▽<G adjustment value:Number>▽<B adjustment value:Number>
RGB setting value Each value –20 to 20
The parameters which can be set at any given point in time can be obtained using the RANGE
command. For details, refer to the RANGE command.
Response
"i:OK" is returned if the parameter was set properly.
For details on other responses, refer to the "Error List".
Description
This sets the RGB adjustment values of the screen color correction.
(1) For models other than SX7 Mark II: It can be executed when the projector is in both the remote mode and
power-on status at the same time.
For SX7 Mark II: It can be executed whenever the projector is in the power-on status.
(2) A “busy” response is given while the zoom or focus lens is being driven.
(Refer to the ZCONTDRV command and FCONTDRV command.)
(3) Although this setting is enabled when Adjustment (ADJUST) is selected by the screen color correction
command (WB), it can be made independently.
(4) This command has the same function as the buttons listed in the table below.
Model Menu
SX50 [Image adjustments] - [Screen color correction] - [Adjustments]
SX6, SX60, X600, SX7, X700,
SX7 Mark II
[Display settings] - [Screen color correction] - [Adjustments]
(5) With this command, the R, G, and B values can be set in a single operation.
(6) When the model SX50 is used, the currently selected input signal and image mode settings are established.
When models other than SX50 are used, a set of settings is established for the system.
(7) The GET command can be used to retrieve the current RGB adjustment values.
For details, refer to the GET command.
Example
Setting
> WBRGB=10, 11, 12 This sets R to 10, G to 11, and B to 12.
< i:OK
Reference
> GET WBRGB or ?WBRGB This retrieves the RGB adjustment values.
< g:WBRGB=-10, 0, 19
(8) Obtain settable parameter range (Min, Max)
> RANGE WBRGB
< WBRGB=N,-20,20,-20,20,-20,20
Any value from -20 to 20 can be set for each color as the RGB adjustment
values.
* Commands are indicated by ">", and responses are indicated by "<".
Commands supported
This defines the environments that support the command (power supply state, input signal state).
SX50
01.00**
SX6
01.01**
SX60
01.01**
X600
01.01**
SX7
01.01**
X700
01.01**
SX7 Mark II
01.02**
O O O O O O O
Setting